Product Overview
Product Category: | Interface - Drivers, Receivers, Transceivers |
Kynix Part #: | KY32-MC33897EFR2 |
Manufacturer Part#: | MC33897EFR2 |
Manufacturer | NXP USA Inc. |
Description: | CAN Interface IC SWCAN PB FREE |
Package: | 14-SOIC (0.154", 3.90mm Width) |
Datasheet: | |
Stock: | Yes |
Quantity: | 27500 |
MC33897EFR2 Images are for reference only:
Product Specifications
Categories | Integrated Circuits (ICs) Interface - Drivers, Receivers, Transceivers |
Manufacturer | NXP USA Inc. |
Series | - |
Packaging | Cut Tape (CT) |
Part Status | Obsolete |
Type | Transceiver |
Protocol | CANbus |
Number of Drivers/Receivers | 1/1 |
Duplex | Half |
Receiver Hysteresis (mV) | 500 |
Data Rate | 83.33Kbps |
Operating Temperature (°C) | -40 ~ 125 |
Package / Case | 14-SOIC (0.154", 3.90mm Width) |
Supplier Device Package | 14-SOIC |
Base Part Number | MC33897 |
Lead Free Status / RoHS Status | Lead free / RoHS Compliant |
Moisture Sensitivity Level (MSL) | 2A (4 Weeks) |
Standard Package | 1 |
Other Names | MC33897EFR2CT |
Mounting Style | SMD/SMT |
Type | CAN Controller |
Data Rate ( kb/s) | 83.33 |
Supply Voltage - Max (V) | 26.5 |
Supply Voltage - Min (V) | 6 |
Packaging | Cut Tape |
Product Type | CAN Interface IC |
Brand | NXP / Freescale |
Number of Transceivers | 1 |
Operating Supply Voltage (V) | 12 |
Subcategory | Interface ICs |
Unit Weight | 0.011923 oz |
Package Description | 1.27 MM PITCH, LEAD FREE, PLASTIC, MS-012AB, SOIC-14 |
EU RoHS Compliant | Yes |
Status | Discontinued |
Telecom IC Type | INTERFACE CIRCUIT |
JESD-30 Code | R-PDSO-G14 |
JESD-609 Code | e3 |
Moisture Sensitivity Level | 2a |
Number of Functions | 1 |
Number of Terminals | 14 |
Package Body Material | PLASTIC/EPOXY |
Package Code | SOP |
Package Shape | RECTANGULAR |
Package Style | SMALL OUTLINE |
Peak Reflow Temperature (Cel) | 260 |
Qualification Status | Not Qualified |
Seated Height-Max (mm) | 1.75 |
Temperature Grade | AUTOMOTIVE |
Terminal Form | Gull-wing |
Terminal Pitch (mm) | 1.27 |
Terminal Position | DUAL |
Length (mm) | 8.65 |
Width (mm) | 3.9 |
Receiver Hysteresis (mV) | 500 |
Base Part Number | MC33897 |
MC33897EFR2 Datasheet PDF Download:
Pinouts
33897 Pin Connections
Pin Definitions
A functional description of each pin can be found in the Functional Pin Description section, beginning on page
33897 | Pin Name | Formal Name | Definition |
1, 7, 8, 14 | GND | Ground | Ground Electrical Common Ground and Heat removal. A good thermal path will also reduce the die temperature. |
2 | TXD | Transmit Data | Data input here will appear on the BUS pin. A logic [0] will assert the bus, a logic [1] will make the bus go to the recessive state. |
3, 4 | MODE0, MODE1 | Mode Control | These Pins control Sleep mode, Transmit Level, and Speed. They have weak pulldowns. |
5 | RXD | Receive Data | Open drain output of the data on BUS. A recessive bus = a logic [1], a dominant bus = logic [0]. An external pull-up is required. |
6, 13 | NC | No Connect | No internal connection to these Pins. Pin 13 can be connected to GND. |
9 | CNTL | Control | Control Provides a battery level logic signal. |
10 | VBATT | Battery | Power input. An external diode is needed for reverse battery protection. |
11 | LOAD | Load | The external bus load resistor connects here to prevent bus pull-up in the event of loss of module ground. |
12 | BUS | Bus | This pin connects to the bus through external components. |
33897 Simplified Internal Block Diagram
Description
The 33897 Series is intended for use as a physical layer device in a Single Wire CAN communications bus. Communications takes place from a single pin over a single wire using a common ground for a current return path. Two data rates are available, with the high rate used for factory or assembly line communications and the lower for actual system communications where the radiated EMI of the higher rate could be an issue.
Two pins control the mode of operation (sleep, low speed, high speed, and high voltage wake-up).
Features
• Waveshaping for low Electromagnetic Interference (EMI)
• Detects and automatically handles loss of ground
• Worst-case Sleep mode current of only 60 μA
• Current limit prevents damage due to bus shorts
• Built-in thermal shutdown on bus output
• Protected against vehicular electrical transients
• Under-voltage lockout prevents false data with low battery
Other data sheets within the file:
MC33897EFR2 Datasheet | ![]() |
PRODUCT AND PROCESS CHANGE NOTIFICATION | ![]() |
Single Wire Can Final Test Expansion to FSL-TJN Qualification Results | ![]() |